EMS USB Driver Problem

[xez]

I've been using the EMS USB adapter for a while now, and it's been working perfectly, except for one thing (of course). Every few minutes, the signal from the pad to the computer going through the adapter seems to die for about ten seconds and then suddenly start working again after. This can get very annoying as I suddenly see a stream of "MISS"es flow across the screen.

I've been working on this problem for a while now, and I have determined that thje problem is in the driver for the adapter. Instead of using the one suggested in the readme for the adapter("emsusb.inf"), I've been using some generic windows one ("usbpadzz.inf"). But, when I went to see if I could get the driver off the disk that came with the adapter (to see if I forgot to copy it during installation), it wasn't there. So, do any of you have the driver file? I can't seem to find it anywhere.