wiring questions

[cartoonhero29]

i had a quick question about the wiring. on the riptide design, when wiring the ground wire, does each arrow have its own ground wire, and then you solder all 4 arrow ground wires to one and to the controller, OR is there one continuous ground wire that goes to all 4 arrows and then the controller? Also, if i were to put lights inside, how would i wire it to sync with the steps?

thanks for the feedback
_________________

[Maxim.Um]

Well, from my experience of pad repair, ground is connected to all four arrows and the controller and each arrow has it's own individual wire connecting to the controller.
_________________

[cartoonhero29]

so theres only one ground wire that connect all four arrows and then leads to the controller? i was reading another guide and it talked about microswitches and male/female connectors for the guidewire, and in riptide's guide it looks like he merged several ground wires into one, so im a little confused
_________________

[Maxim.Um]

What I did when I refurbished my afterburner was I got a couple of wires that were cut, soldered them all together to make one big wire, then soldered that one long wire to the sensors dedicated to ground. I don't know what you would need microswitches or male/female connectors for.

To put it simply: One wire connects all sensors made for ground, then connects to ground on your controller.. No seperate wires for ground.

I hope this helps some.
_________________

[cartoonhero29]

thanks alot, apprechiate it
_________________

[Maxim.Um]

No Problem.
_________________