|
||||
 Forums FAQ
 Search
 Memberlist
 Usergroups
 Register
 Profile
 Login to check your private messages
 Login
|
||||
 |
| Search found 7 matches |
| Author | Message |
|---|---|
 Topic: broken right arrow on metal pad |
|
| necorn Replies: 2 Views: 17671 |
 Forum: Bemani Controllers Posted: Sun Jul 05, 2009 11:28 pm Subject: broken right arrow on metal pad |
| so is the problem with the squashed wire?
like has this same problem happened before with other users? i dont want to unnecessarily open up a tiny wire without any skill in that area if there is ano ... |
|
| Topic: broken right arrow on metal pad |
|
| necorn Replies: 2 Views: 17671 |
Forum: Bemani Controllers Posted: Sat Jul 04, 2009 10:08 pm Subject: broken right arrow on metal pad |
| hey guys
for a while now after i modded my mat the right arrow was acting up a bit, sometimes not working for a few seconds then all of a sudden working again there are days where it only acts up fo ... |
|
| Topic: A couple of pads from [b]down under[/b] with some home mods! |
|
| necorn Replies: 3 Views: 11952 |
Forum: Bemani Controllers Posted: Mon May 11, 2009 11:31 pm Subject: A couple of pads from [b]down under[/b] with some home mods! |
| whoa those are almost exactly like my mat when i first bought them
good job on replacing all the panels btw im from australia too, so where did you go to get all your materials and how much did it ... |
|
| Topic: help needed fixing up panels on my "metal" mat |
|
| necorn Replies: 2 Views: 9193 |
Forum: Bemani Controllers Posted: Fri May 08, 2009 5:07 pm Subject: help needed fixing up panels on my "metal" mat |
| is the aluminum sheet metal ive got now (0.5mm thick) too thick to stick on as a contact? people have been recommending 26 gauge, and it seems ive got 24 gauge metal...
btw i dont think im too clear ... |
|
| Topic: help needed fixing up panels on my "metal" mat |
|
| necorn Replies: 2 Views: 9193 |
Forum: Bemani Controllers Posted: Wed May 06, 2009 6:24 am Subject: help needed fixing up panels on my "metal" mat |
| hey people
recently i replaced the panels on my 3rd party metal mat with polycarbonate sheets 3mm thick because the original panels were cracking. i also stuck a sheet of .5mm thick aluminum sheet me ... |
|
| Topic: help modding my pads on my dance mat |
|
| necorn Replies: 2 Views: 7707 |
Forum: Bemani Controllers Posted: Sat Apr 25, 2009 1:21 am Subject: help modding my pads on my dance mat |
| the arrows
btw i finished modding it and it worked fine for a week or so, but later i found the metal was bending too much and that caused the whole panel to stoop down and the foil at the bottom w ... |
|
| Topic: help modding my pads on my dance mat |
|
| necorn Replies: 2 Views: 7707 |
Forum: Bemani Controllers Posted: Sun Apr 12, 2009 11:42 pm Subject: help modding my pads on my dance mat |
| hey guys this is my first post
well, basically i own a crappy TX1000 mat which i got a few weeks ago, and already the pads have cracked. in a few more days of playing i reckon the pads will split ... |
|
All times are GMT - 8 Hours |
Powered by phpBB 2 © 2001, 2002 phpBB Group